Tacoma High Clearance Bumper Installation Guide.
OffStreetBuilt is NOT responsible for any damages caused from High Clearance Bumper Installation.
Step 1 - Layout.
Remove Tail Light and Bed for ease of cutting. With a permanent marker mark 1 ⅞ inch from bottom of tail light. Next mark 3 ¾ from top of body line down.
Step 2 - Cutting
Using a Cutoff wheel on a grinder or any other means of material cutting, cut below the line that you have marked with permanent marker.
Step 3 - Final Cutting
Remove the inner structure of the bed. Sawzall is the easiest method in this process.
Step 4 - Install.
Install the provided trim supplied in the bag,and prepare all the supplied hardware to install the bumper. DON'T FORGET TO INSTALL THE INNER FRAME BOLT. Start with the middle frame bolt and after that is installed fingers tightly, install the inner frame bolt and outer frame bolts.
Step 5 - Quarter Panel Bracket , Tube Caps, Trim
Drill from the inner side of the quarter panel and secure it with the provided hardware. If need be, adjust the latch until it has a firm solid clunk when secured into place. Use the provided tube caps and insert them into the open tubes. A rubber mallet might be required to help them seat into place. Cut the supplied trim to the right length and firmly press onto the cut edge with your hand.